Gigabyte GA-970A-UD3P Instrukcja Użytkownika Pobierz pdf (Strona 61)

- 61 -

Conguring SATA Hard Drive(s)

3-2 Installing the SATA RAID/AHCI Driver and Operating System

WiththecorrectBIOSsettings,youarereadytoinstalltheoperatingsystem.

A. Installing Windows 8/7

(ThefollowinginstructionsuseWindows8astheexampleoperatingsystem.)

Step 1:

You need to install the SATA RAID/AHCI driver during the OS installation. Use an alternative system to copy

theSATARAID/AHCIdriverfromthemotherboarddriverdisktoaUSBashdrive.CopytheHw8 folder under

BootDrv in the driver disk.

Step 2:

BootfromtheWindows8setupdiskandperformstandardOSinstallationsteps.Whenthescreenrequesting

you to load the driver appears, select Browse.

Step 3:

ThenbrowsetotheUSBashdriveandselectthelocationofthedriver.Thelocationsofthedriversareasfollows:

RAIDdriverforWindows832-bit:Hw8\RAID\x86

RAIDdriverforWindows864-bit:Hw8\RAID\x64

AHCIdriverforWindows832-bit:Hw8\AHCI\W8

AHCIdriverforWindows864-bit:Hw8\AHCI\W864A

ForWindows7,browsetotheHw7 folder.

Step 4:

WhenascreenasshowninFigure1appears,selectAMD AHCI Compatible RAID Controller and click Next

to load the driver and continue the OS installation.

Figure 1

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 87 88

Brak uwag

Gigabyte GA-970A-UD3P Instrukcja Użytkownika Strona 61