Gigabyte GA-970A-UD3P Instrukcja Użytkownika Pobierz pdf (Strona 53)

- 53 -

Conguring SATA Hard Drive(s)

C-1.UEFIRAIDConguration

ThismodesupportsWindows864-bitinstallationonly.

Step 1:

In BIOS Setup, go to BIOS Features and set OS Type to Windows 8 and CSM Support to Never.(Figure2)

Save the changes and exit BIOS Setup.

Step 2:

Restartyourcomputerandpress<F12>toenterthebootdevicecongurationmenu.Usetheupordownarrow

key to select UEFI: Built-in EFI Shell. Press <Enter> to access the screen as shown in Figure 3. Follow the

steps below and enter the commands to access the RAID setup utility.

1. Enter drvcfg at Shell and press <Enter>:

Shell> drvcfg

2. WhenDrv [XX] Ctrl [XX] Lang [eng] appears, enter the following commands at Shell again:

Shell> drvcfg -s XX XX

(XXs are the values shown in the brackets after Drv and Ctrlabove,whichmayvarybyharddrives.)

Then press <Enter> to enter the RAID setup utility.

Figure 2

Figure 3

EFI Shell version 2.31 [4.653]

Current running mode 1.1.2

Device mapping table

fs0 : Removable HardDisk Alias hd12d0b blk0

PciRoot (0x0)/Pci (0x10, 0x0)/USB (0x3, 0x0)/HD (1.MBR,0x016777a6, 0x3f, 0x1e1fc0)

fs1 : Removable CDRom Alias cd14c0b blk1

PciRoot (0x0)/Pci (0x11, 0x0)/Scsi (0x2, 0x0)/CDROM (0x1,0x6e, 0X1A0263)

......

Press ESC in 1 seconds to skip startup.nsh, any other key to continue.

Shell> drvcfg

Congurable Components

Drv [59] Ctrl [CF] Lang [eng]

Shell> drvcfg -s 59 cf

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 87 88

Brak uwag

Gigabyte GA-970A-UD3P Instrukcja Użytkownika Strona 53